If there are leaks, don't panic - just remove that connection and reseal it. If there are no leaks, you have done a great job. Release the tub drain and check the all the visible pipe connections under the tub while the water is draining. ![]() If there are no leaks at the bottom drain, continue filling the tub until the water runs over and down the overflow drain. The overflow tube is a safety feature that channels water that has overfilled the tub back down into the drain pipes before it can spill over the edge of the tub. Allow the water to set for at least an hour to test the drain seal. Estimated Cost: 3 to 10 Problems with a leaky bathtub are often traced to the overflow tube or overflow drain assembly. Step 5Ĭlose the tub drain and fill the tub with water. Tighten the connecting nuts of the tee by hand from behind the tub. Install the drain in the tub shoe from inside the tub with silicone caulk or plumber’s putty. Insert the over section into the top of the tee and connect the overflow plate from inside the tub. If you can get to the trap then you can get to the overflow. Slide the tub shoe into the side of the tee and align the drain inside the tub. Usually the overflow tube is accessed from the bottom. Insert the drain tee into the trap adaptor just below the floor. Install the new center outlet waist and overflow. Install your new center outlet bathtub according to the manufacturer’s instructions. Install a trap adaptor above the p-trap within six inches of the floor this is for the new waist and overflow to connect to the tub drain. Add plumber’s putty to the toe-touch and place it in the empty drain hole. Remove line to old drain shoe with a reciprocating saw and unscrew the shoe by hand. Remove line to old drain shoe with a reciprocating saw and unscrew the shoe by hand. Remove old spout by unscrewing it from the rear space of the bathtub with a basin wrench. ![]() Install a new p-trap and drain line under the marked location of your new center-outlet tub drain. Remove old spout by unscrewing it from the rear space of the bathtub with a basin wrench. If your drain is made of PVC, glue a coupling on the open end of the drain line. Install a rubber coupling if your drain is made out of metal. Step 3Ĭut the existing p-trap off the tub drain line under the floor with a reciprocating saw. This will allow enough room for the new center drain to connect to the bottom of the tub. ![]() If you have a conventional floor with a crawlspace underneath, you only need to cut a 12-inch hole in the floor with a circular saw. If you have a concrete floor, use a concrete cutoff saw to remove a four- to six-inch path from the old end drain to the new marked center-outlet drain location. Mark the location of the new center drain according to the manufactures instructions not all tubs have the same exact drain location.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |